Rinse the weather stripping with clean water to remove any soap residue. Make sure that the new weatherstripping is clean.

Winter Prep Where To Grease A Car Door Weather Stripping Car Maintenance Car

Then pull the tape free and spray silicone on the weather strip on the other doors and trunk lid.

How to change weather stripping on car door. How to replace a door sweep or bottom seal is one of the first video s where i did a voice over because the customer was a work a home lady who needed the. Then measure the length of the sides of the frame. Clean up any adhesive messes with the brake cleaner.

Before the adhesive dries replace the new weatherstripping. Step 3 apply adhesive. Apply weatherstripping adhesive sparingly to the strip and to the surface of the frame.

Begin by measuring around the door with a tape measure to determine what size of the weather stripping that you will. Let that dry completely then squeeze a bead of the adhesive onto the weather strip and the car door and let that dry. Step 2 after cleaning wipe the surface dry with a clean towel.

Step 2 clean the area. Replacing car door weather stripping. Step 1 measure and prepare.

Tack the door weather stripping in place but don t drive the nails home yet. Apply a generous amount of silicone based spray over the entire weather stripping surface and wait two or three minutes before wiping the excess spray off the weather stripping. Really enthusiastic owners will see bad weatherstripping in one part of the car as a sign that all of it is failing and will replace all the stripping as preventive maintenance.

Then apply a second coat to both surfaces and press the weather strip into place. Nails into the wood flange and position the weatherstripping so the entire length of the foam seals against the door. To take off the old weather stripping remove any screws holding the pieces in place and then tug away at the stripping as well as the underlying adhesive layer to remove it from the car applying adhesive remover if necessary.

Before placing the new stripping first clean and dry the channel with a towel. Either rinse it off and dry it thoroughly or use fine grain sandpaper to remove any unwanted bumps and rough spots. Hold it in place with masking tape until the adhesive dries about 45 minutes.